Spindle Taper 7/24 Taper #40/ Grip MAS This specification uses the spindle No. 40 7/24 taper / Grip MAS tool holder. The grip type and retention knob type of ATC are specified separately.
Retention Knob: Special (Center-Through) (7/24 Taper #40)
Retention Knob: Special (Center-through) (7/24 Taper #40) The spindle collet applicable to the special (center-through) retention knob is installed. *Tool retention knob is not included. *The through-spindle coolant specification requires a dedicated r
Interface for Workpiece seating detection (1 line)
Interface for Workpiece Holding Detection (1 Circuit) For the workpiece holding detection interface, pneumatic 1 circuit 1 port are provided on the in-machine ceiling (right side). The panel is installed on the upper right of the machine front and the p
Interface for Hydraulic fixture (hydraulic 2 circuits )
Interface for Hydraulic Fixture (Hydraulic 2 Circuits) For the fixture interface, hydraulic 2 circuit 4 ports are provided on the in- machine ceiling (right side). The hydraulic unit (made by NACHI) put on the oil pan with casters is placed at the rear
Tool storage capacity 60 tools
Tool Storage Capacity 60 Tools Chain-type magazine Tool capacity: 60 tools Technical random address type Max. tool diameter - With adjacent tools: f80 mm (dia.3.15 inch.) - Without adjacent tools: f125 mm (dia. 4.92 inch.) Max. tool length: 300 mm (11.
We use cookies to optimize our website for you and to be able to improve it continuously. By clicking the "Accept" button, you expressly agree to the use of cookies. For further information on cookies, please refer to our privacy policy.